现今电力电子产业的的发展,由微处理器控制的丹佛斯变频器配备了先进的自我诊断功能。这些诊断系统可以提供以下帮助: 检查变频器内部功能块的是否正确操作。 实时监控运行参..
029-81616045 立即咨询发布时间:2022-12-14 热度:
现今电力电子产业的的发展,由微处理器控制的丹佛斯变频器配备了先进的自我诊断功能。这些诊断系统可以提供以下帮助:
ERROR CODE | DESCRIPTION | WARNING | ALARM | TRIP LOCK |
1 | Under 10 Volts (10 VOLT LOW) | YES | ||
2 | Live zero fault (LIVE ZERO ERROR) | YES | YES | |
3 | No motor (NO MOTOR) | YES | ||
4 | Mains failure (MAINS PHASE LOSS) | YES | YES |
YES |
5 | Voltage warning high (DC LINK VOLTAGE HIGH) | YES | ||
6 | Voltage warning low (DC LINK VOLTAGE LOW) | YES | ||
7 | Overvoltage (DC LINK OVERVOLT) | YES | YES | |
8 | Undervoltage (DC LINK UNDERVOLT) | YES | YES | |
9 | Inverter overloaded (INVERTER TIME) | YES | YES | |
10 | Motor overloaded (MOTOR TIME) | YES | YES | |
11 | Motor thermistor (MOTOR THERMISTOR) | YES | YES | |
12 | Current limit (CURRENT LIMIT) | YES | YES | |
13 | Overcurrent (OVERCURRENT) | YES | YES | |
14 | Earth fault (EARTH FAULT) | YES | YES | |
15 | Switch mode fault (SWITCH MODE FAULT) | YES | YES | |
16 | Short circuit (CORR. SHORT CIRCUIT) | YES | YES | |
17 | Serial communication timeout (STD BUSTIMEOUT) | YES | YES | |
18 | HP fieldbus timeout (HPFB TIMEOUT) | YES | YES | |
19 | Fault in EEPROM on control card | YES | ||
20 | Fault in EEPROM on power card | YES | ||
21 | Auto-optimization OK (AUTO MOTORADAPT OK) | YES | ||
22 | Auto motor adaptation fault (AMA FAULT) | YES | ||
23 | Brake test failed (BRAKE TEST FAILED) | YES | ||
25 | Brake resistor short circuit (BRAKE RESISTOR FAULT) | YES | ||
26 | Brake resistor power 100% (BRAKE POWER 100%) | YES | YES | |
27 | Brake transistor short circuit (BRAKE IGBT FAULT) | YES | ||
29 | Heat sink temperature too high (HEAT SINK OVERTEMP) | YES | ||
30 | Motor phase U missing (MISSING MOT. PHASE U) | YES | ||
31 | Motor phase V missing (MISSING MOT. PHASE V) | YES | ||
32 | Motor phase W missing (MISSING MOT. PHASE W) | YES | ||
33 | Quick discharge NOT OK (QUICK DISCHARGE FAIL) | YES | YES | |
34 | HPFB fieldbus communication fault (HPFB COMM. FAULT) | YES | YES | |
35 | Out of frequency range (OUT FREQ RNG/ROT LIM) | YES | ||
36 | Main AC input power fail (MAINS FAILURE) | YES | YES | |
37 | Inverter fault (GATE DRIVE FAULT) | YES | YES | |
39 | Check params 104 i 106 (CHECK P.104 & P.106) | YES | ||
40 | Check params 103 i 105 (CHECK P.103 & P.106) | YES | ||
41 | Motor too large (MOTOR TOO BIG) | YES | ||
42 | Motor too small (MOTOR TOO SMALL) | YES | ||
43 | Brake fault (BRAKE FAULT) | YES | YES | |
60 | Safety stop (EXTERNAL FAULT) | YES | YES | |
61 | Output frequency low (FOUT<FLOW) | YES | ||
62 | Output frequency high (FOUT>FHIGH) | YES | ||
63 | Output current low (IMOTOR<ILOW) | YES | YES | |
64 | Output current highi (IMOTOR>IHIGH) | YES | ||
65 | Feedback low (FEEDBACK<FDB LOW) | YES | ||
66 | Feedback hgh (FEEDBACK>FDB HIGH) | YES | ||
67 | Reference low (REF.<REF.LOW) | YES | ||
68 | Reference high (REF.>REF.HIGH) | YES | ||
69 | Temperature auto derate (TEMP. AUTO DERATE) | YES | ||
99 | Alarm unknown (UNKNOWN ALARM) | YES | YES |
错误代码 | 描述 | 警告 | 报警 | 旅行锁 |
1 | 低于10伏(10伏低) | 是 | ||
2 | 实时零故障(实时零错误) | 是 | 是 | |
3 | 无马达(NO MOTOR) | 是 | ||
4 | 电源故障(电源相位丢失) | 是 | 是 |
是 |
5 | 电压警告过高(DC LINK VOLTAGE HIGH) | 是 | ||
6 | 电压警告过低(DC LINK VOLTAGE LOW) | 是 | ||
7 | 过电压(DC LINK OVERVOLT) | 是 | 是 | |
8 | 欠压(DC LINK UNDERVOLT) | 是 | 是 | |
9 | 逆变器过载(INVERTER TIME) | 是 | 是 | |
10 | 电机过载(MOTOR TIME) | 是 | 是 | |
11 | 电机热敏电阻(MOTOR THERMISTOR) | 是 | 是 | |
12 | 电流限制(CURRENT LIMIT) | 是 | 是 | |
13 | 过电流(OVERCURRENT) | 是 | 是 | |
14 | 接地故障(地球故障) | 是 | 是 | |
15 | 开关模式故障(SWITCH MODE FAULT) | 是 | 是 | |
16 | 短路(CORR。SHORT CIRCUIT) | 是 | 是 | |
17 | 串行通讯超时(STD BUSTIMEOUT) | 是 | 是 | |
18 | HP现场总线超时(HPFB TIMEOUT) | 是 | 是 | |
19 | 控制卡上的EEPROM故障 | 是 | ||
20 | 功率卡EEPROM中的故障 | 是 | ||
21 | 自动优化正常(自动调整正常) | 是 | ||
22 | 汽车电机自适应故障(AMA故障) | 是 | ||
23 | 刹车测试失败(刹车测试失败) | 是 | ||
25 | 制动电阻器短路(制动电阻器故障) | 是 | ||
26 | 制动电阻器功率100%(制动功率100%) | 是 | 是 | |
27 | 制动晶体管短路(BRAKE IGBT FAULT) | 是 | ||
29 | 散热器温度过高(HEAT SINK OVERTEMP) | 是 | ||
30 | 电机U相缺失(M相相缺U相) | 是 | ||
31 | 电动机V相缺失(相V缺失) | 是 | ||
32 | 电机W相缺失(相M缺相W) | 是 | ||
33 | 快速放电不正确(快速放电失败) | 是 | 是 | |
34 | HPFB现场总线通信故障(HPFB COMM。FAULT) | 是 | 是 | |
35 | 超出频率范围(OUT FREQ RNG / ROT LIM) | 是 | ||
36 | 主交流输入电源故障(电源故障) | 是 | 是 | |
37 | 逆变器故障(GATE DRIVE FAULT) | 是 | 是 | |
39 | 检查参数104 i 106(检查P.104和P.106) | 是 | ||
40 | 检查参数103 i 105(检查P.103和P.106) | 是 | ||
41 | 电机太大(MOTOR TOO BIG) | 是 | ||
42 | 电机太小(MOTOR TOO SMALL) | 是 | ||
43 | 制动故障(BRAKE FAULT) | 是 | 是 | |
60 | 安全停止(外部故障) | 是 | 是 | |
61 | 输出频率低(FOUT <FLOW) | 是 | ||
62 | 输出频率高(FOUT> FHIGH) | 是 | ||
63 | 输出电流低(IMOTOR <ILOW) | 是 | 是 | |
64 | 输出电流高(IMOTOR> IHIGH) | 是 | ||
65 | 反馈低(FEEDBACK <FDB LOW) | 是 | ||
66 | 反馈hgh(反馈> FDB高) | 是 | ||
67 | 参考低(REF。<REF.LOW) | 是 | ||
68 | 参考高(REF。> REF.HIGH) | 是 | ||
69 | 温度自动降额(TEMP。AUTO DERATE) | 是 | ||
99 | 警报未知(未知警报) | 是 | 是 |